Mustang Vinyl Decklid Panel Installation Instructions

Tools Required:

• Squeeggee
• Spray bottle
• Liquid soap
• Terry cloth or towel

First remove any and all emblems including the Ford Oval emblem and any other emblem that your   specific model came with. Also remove your license plate.

Next, use rubbing alcohol to wash all wax and dirt from the surface where the decklid panel will be installed.

Make a soapy solution of by combining three to four drops of dishwashing detergent with warm water.

Spray the solution over the decklid area where the new vinyl overlay will be installed.

Once the area is saturated, start with one section at a time and peel off the paper backing material from the black vinyl.

Align the vinyl in place and use a squeegee to apply it to the vehicle.  Work from the center of the vinyl to the edges, slowly pushing any air bubbles and excess solution out from under the decal. Please be patient with this procedure. It may take several minutes for the vinyl to finally adhere. Repeat this procedure for the other two sections and your done!

Use your terry cloth towel to wipe off any excess solution from your Stang.

Visit StangMods to purchase your Vinyl Mustang Decklid Trim Panel and other Mustang vinyl decals.